2000-2016 Jeep Wrangler / Dana 30 Axle Bombshell Differential Cover (Unpainted) by Poison Spyder Customs
Product Reviews for 2000-2016 Jeep Wrangler / Dana 30 Axle Bombshell Differential Cover (Unpainted) by Poison Spyder Customs
Poison Spyder Bombshell Diff Covers are designed to protect your gears, lockers and diff cover bolts from the most punishing rocks and trail hazards. The stock covers your Jeep came with are weak, stamped sheetmetal. Even a moderate tap with a rock can cave it in against your ring gear, causing potential damage to the gears, locker and carrier bearings, not to mention a difficult, messy trail fix. Even more common, though less catastrophic, is "peel back" that can occur when sliding over a rock causes the lip of the cover to peel up, allowing your gear oil to drain causing a hazard for both your Jeep and the environment. The Bombshell Diff Cover is your best insurance against each of these hazards.
The Bombshell differential cover is cast from highly ductile nodular iron—the same material drag racing differential housings are cast from to handle thousands of horsepower. The design of the Bombshell incorporates recesses to protect the diff cover bolt heads from trail damage, while the profile of the Bombshell acts as a ramp to help slide your Jeep up and over the most troublesome pumpkin-eaters. The ramp profile also results in an extremely thick& up to 1" thick—cross-section around the bolt ring, where contact with the rocks is most likely. Throughout the rest of its cross-section the Bombshell is the thickest cast differential cover on the market, from 7/16" to a brutal 1/2" thick at the outermost surface.
The Dana 30 Bombshell can now be used on STOCK Jeep Wrangler JK and TJ, front or rear axles, with no requirement for aftermarket track bars or suspension modifications! Now you can install the Bombshell Dana 30 Diff Cover on to your bone stock Jeep, straight off the showroom floor! This re-design also includes moving the gear oil fill hole to the stock fluid level height so there's no more research, guesswork or measuring—simply fill the diff to the level of the fill hole.
The part number for this item is Poison Spyder 42-11-030 and it fits 2000-2016 Jeep Wrangler / Dana 30 Axle models.
This cover is shipped unpainted / raw and is ready to be painted or powder coated.