HP Sticky Shield Armor 1/8" Thick Adhesive Backed Heat Shielding 1' by 2'
Product Reviews for HP Sticky Shield Armor 1/8" Thick Adhesive Backed Heat Shielding 1' by 2'
So you've got some heat issues that you think are just a little too critical for our standard exhaust wraps.. Worry no more! Made from a dense layer of 1/8” fiberglass insulation shielded by a rugged layer of .003” thick aluminum, HP Sticky Shield may be cleaned after installation and is resistant to the elements. It's designed to be used on turbo manifolds, down pipes exhaust pipes or whatever else you need to protect. Get ready to control heat in a big way.
HP Sticky Shield Adhesive Backed Armor can easily be used on flat surfaces or wrapped around components. It is flexible and easy to cut to fit where you need it to be.
HP Sticky Shield Adhesive Backed Armor can withstand 1100 F continuous and up to 2000 F intermittent. It's easy to install because it's flexible and easy to cut. It has a protective outer armor shell that can be cleaned, too. Wrap this stuff around the exhaust system and Heatshield Products says it keeps the heat in, which creates a scavenging effect, allowing exhaust gases to flow out of the system faster. HP Sticky Shield Armor is a breeze to install, simply peel and stick.
Thicker, more durable, and better at eliminating radiant heat than standard exhaust wraps, this easy to install adhesive backed product will get the job done.
The part number for this item is 180020 and it is 1/8" Thick, measuring 1 foot long by 2 feet wide. It can be easily cut with a razor knife if desired.